Loading...

Program your Rogers Champion remote

First, program the Rogers remote for your TV.

Since the Rogers remote control is a universal remote, you can program it for other components by repeating the steps below and substituting the TV button with the respective device button (DVD, Audio, etc.).

  1. Press and hold SETUP until LED blinks twice.
  2. Press TV mode key.
  3. Press and hold OK.
  4. Release key when TV turns off.
  5. Press the POWER button to check whether it turns on the TV.

If you have a NextBox 3.0 or NextBox 4K, follow these steps to pair for Radio Frequency (RF). RF allows you to control your NextBox with your remote without line of sight, through a door or a wall.

  1. Press and Hold the SETUP key + UP ARROW  at the same time to put the remote control in pairing mode.
  2. The CABLE button will continually flash until pairing is completed. Once pairing is successful, the LED under the CABLE key will flash twice.

Once the remote is paired in RF to a NextBox 3.0 or NextBox 4K, it will not work on other Digital set-top boxes. If you want the remote to work on multiple NextBoxes, follow these steps to unpair from RF and use in IR mode.

  1. Press and Hold the SETUP key + DOWN ARROW at the same time to put the remote control in pairing mode.
  2. The CABLE button will continually flash until unpairing is completed. Once unpairing is successful, the LED under the CABLE key will flash twice.
 support-choose-tv-champion-remote