Loading...

Pair the Thermostat to the Touchpad

The following steps outline how to add a CT30, Centralite Pearl or Salus Optima thermostat to the touchpad.

CT-30

  1. Select Settings.
  2. Enter the Master Code.
  3. Select Home Devices.
  4. Select Thermostats.
  5. Select Add a Thermostat.
  6. Tap Next.
  7. Reset the thermostat to factory default to place it in Search mode.
    • Press the Mate label twice (below the radio tower icon).
    • The Mate label blinks to indicate that the device is in Search mode.
    • When the thermostat device is found, an icon is displayed for that device.
  8. Tap Done.
  9. The system notes the number of devices that were found and paired.
  10. Tap Next.
  11. The Configure thermostats screen displays all the paired thermostat devices.

Centralite Pearl

  1. Press the Mode button until OFF is displayed.
  2. Before the thermostat goes into sleep mode, press and hold the Hidden Menu button (located in the empty space between the Hold button and Fan button), and swipe down on the right slider.
  3. When the display changes to 01 (indicating that the thermostat is in programming mode), release the Hidden Menu button.
  4. Use the slider on the right to go through the menu until 12 is displayed.
  5. Press the Hold button. The display will flash 00.
  6. Press Set Point Up (above the slider) to change the display to 01 and press Hold to enter.
    • The thermostat will start scanning for available networks.
    • The green Zigbee status indicator on the thermostat will start to flash.
  7. Make sure the system is disarmed.
  8. On the touchpad, select Settings on the Home Screen.
  9. Enter your Master Access Code (4 digit code).
    • Your Master Access Code is the same code that you use to manage your system.
  10. Select Home Devices under the Categories list.
  11. Scroll down and select Thermostats, then select Add Thermostat.
  12. On the Locating Thermostat Devices screen, press Next.
    • The system can take up to 30 seconds to find the thermostat.
  13. On the touchpad, a pairing icon will appear and change to a Thermostat icon once the pairing is complete.
    • This can take 2 to 5 minutes.
  14. Select Done once the Thermostat icon appears and hit Next to confirm.
  15. The Thermostat icon will be shown again. Tap the icon to customize the name.
  16. Select Return to Menu to complete the pairing.

Salus Optima

  1. Go to Settings and enter the installer or master code.
  2. Select Home Devices.
  3. Select Thermostats.
  4. Select Add a Thermostat.
  5. Tap Next.
  6. Press and hold the Mode button for 5 seconds until the menu is displayed (the word Clock should be flashing).
  7. Advance through the menu using the slider-ring until Pair is displayed. Press Mode and and Will Pair will appear.
  8. Press Mode again and it will show Pairing and start a 10 minute discovery mode countdown.
    • Once detected, Identifying will be displayed on the screen.
  9. Tap Done.
    • The system will note the number of devices that were found and paired.
  10. Tap Next.
    • The Configure Thermostats screen will open, showing all paired thermostat devices.